User's Manual

36 6390-009-001 REV B www.stryker.com
Return To Table of Contents
Installation Guide
INSTALLING THE OPTIONAL WHEEL GUIDE (CONTINUED)
3. With the vehicle door closed, align the wheel kicker rail (6390-001-176) (G) against the wall (cabinet).
4. Using a tape measure, measure 1-1/2 in (3.81 cm) from the foot end of the wheel kicker rail and the door panel.
5. Using a pencil, make a small mark on the wall (cabinet) noting the location of the back of the wheel guide rail.
6. With the assistance of someone else, place all five wheel turner supports (6390-001-174) (E) in the approximate
mounting locations.
7. Set the wheel kicker rail on top of the wheel turner supports by referencing the mark made in step 5 for location
of the wheel kicker rail.
Notes:
Ǩɣ Ensure that the holes in the wheel kicker rail align with the open areas in the vehicle patient compartment for
adequate wheel kicker rail support.
Ǩɣ Each hole is spaced 1 in (2.54 cm) apart for multiple installation options.
Ǩɣ Space all five wheel turner supports as evenly as possible. Install all five wheel turner supports.
8. Using a pencil, mark each of the holes in the five areas where a wheel turner support will be located on the wall
(cabinet) as shown in Figure 29.
Note: Make sure that the wheel kicker rail does not move during this process or holes could be made in the wrong
position.
9. Remove the wheel kicker rail and wheel turner supports.
10. Using a drill and a 1/4” drill bit, drill each of the marked hole locations (marked in step 8) into the wall (cabinet).
CAUTION
To avoid the risk of vehicle damage, be aware of items around your selected drill hole locations during installation.
11. Select the appropriate length 1/4-20 hex head cap screws, ASTM-F835 or SAE grade 8 (not supplied), for your
wheel kicker rail installation.
12. Using a 7/16” socket with a 3/8” drive ratchet and a 7/16” combination wrench, install the screws (selected in step
11) to secure the wheel kicker rail to the wheel turner support through the spacer (6390-001-173) (D), if required,
then to the wall of the vehicle patient compartment as shown in “Figure 27: Wheel Guide Installation without
Spacers” on
page 34 or “Figure 28: Wheel Guide Installation with Spacers” on page 34.
13. Using a T25 Torx driver, install the two pan head machine screws (0023-296-000) (B) to secure the wheel turner
cap (6390-001-178) (H) to the head end of the wheel kicker rail.
14. Slide the wheel kicker rail bumper (6390-001-175) (F) over the wheel kicker rail from the foot end of the vehicle
patient compartment to the head end.
15. Using a 5/32” Allen wrench, install the two flat head cap screws (0001-195-000) (A) through the wheel guide
assembly (6390-001-017) (C) hinge and the wheel kicker rail to the wheel turner nut (6390-001-191) (J) as shown
in ”Figure 29: Optional Wheel Guide Kit Components - 6390-027-000” on
page 35.
16. Install the four wheel covers (6390-001-206) (L) to the patient right side of the cot that is to be used with the wheel
guide assembly. See “Installing Cot Wheel Covers” on
page 37.