User's Manual

24 6390-009-001 REV B www.stryker.com
Return To Table of Contents
Installation Guide
Figure 10: Insert Floor Plate Attachment Bracket Figure 11: Secure Safety Hook
Figure 12: Measure for Anchor Installation
INSTALLING THE FLOOR PLATE (WITH A WOOD FLOOR) (CONTINUED)
Install the Anchor Assembly
34. Insert a floor plate attachment bracket (6390-001-108) at the foot end of the vehicle patient compartment to install
the safety hook (6390-001-148) (Figure 10). Line the notches with the tabs to insert, then slide the bracket into
the floor plate assembly.
WARNING
Failure to install the safety hook can cause injury to the patient or operator. Install and use the safety hook as described
in this manual.
35. Using a 5/32” Allen wrench, install two flat head cap screws (0001-194-000) to secure the safety hook to the
floor plate assembly (Figure 11).
36. Lift the vehicle bumper to the raised position (if
equipped).
37. Measure from the end of the floor plate to the end
of the bumper to determine how far you can move
the anchor in towards the head end (Figure 12).
Note: If the distance measured is less than 18 in
(46 cm), you can shift Power-LOAD in closer to the
head end of the vehicle patient compartment by
the difference of 18 in (46 cm) and the measured
distance.