User's Manual

64 6390-009-001 REV B www.stryker.com
Return To Table of Contents
Operation Guide
LOADING A COT INTO A VEHICLE MANUALLY (POWER-PRO POWER LOSS)
WARNING
• Loading and/or unloading an occupied cot into a vehicle requires a minimum of two (2) trained operators.
• Make sure that all occupants enter the vehicle patient compartment after the Power-LOAD compatible cot has been
loaded into the vehicle patient compartment.
1. Lift the vehicle bumper to the raised position (if
equipped).
2. Raise the lifting arms to guide and pull the trolley out
of the vehicle patient compartment as shown in Figure
55.
3. Raise the cot to the load position.
4. Push the cot into Power-LOAD until the cot load wheel
pins lock into position as shown in Figure 56. Ensure
that the cot is aligned with the lifting arms when loading.
CAUTION
To avoid the risk of equipment damage, do not slam the cot
into the trolley when loading.
5. Check the head end lock LED indicators to ensure that
the cot is locked into Power-LOAD.
• If the LEDs are solid green, the cot head end is
locked into Power-LOAD.
• If the LEDs are flashing red, the cot head end is
not locked into Power-LOAD.
6. Press the up () button on the Power-LOAD control
panel as shown in Figure 57 to raise the lifting arms to
the highest position.
Note: The cot legs do not retract.
7. Operator 1 (Foot End) − Grasp the cot frame at the
foot end. Squeeze and hold the cot manual release.
8. Operator 2 (Side) − Grasp the base frame. After the
foot end operator squeezes the cot manual release,
retract the undercarriage with one hand and stabilize
the cot with your other hand.
CAUTION
To avoid the risk of equipment damage, do not push the cot
into the vehicle patient compartment until the cot base is
fully retracted.
Figure 55
Figure 56
Figure 57