User's Manual

www.stryker.com 6390-009-001 REV B 13
Return To Table of Contents
Summary of Safety Precautions
PINCH POINTS
Figure 3: Pinch Points
• To avoid the risk of equipment damage, do not slam the cot into the trolley when loading.
• To avoid the risk of equipment damage, do not push the cot into the vehicle patient compartment until the cot base
is fully retracted.
• Do not let go of the manual release until the cot locks into position at the head end. If you let go too early, then
the cot base may prevent the cot from properly locking into Power-LOAD.
• DO NOT STEAM CLEAN OR ULTRASONICALLY CLEAN THE UNIT.
• Maximum water temperature should not exceed 180°F/82°C.
• Allow unit to air dry prior to use.
• Failure to comply with these instructions may invalidate any/all warranties.
CAUTION (CONTINUED)