User's Manual

52 6390-009-001 REV B www.stryker.com
Return To Table of Contents
Figure 37 Figure 38
LOADING A PERFORMANCE-PRO COT INTO A VEHICLE (MODEL 6085/6086 WITH THE POWER-LOAD
OPTION) (CONTINUED)
Operation Guide
6. Press the up (Ç) button on the Power-LOAD control panel to raise the lifting arms to the highest position as shown
in Figure 37.
Note: The cot legs do not retract.
7. Operator 1 (Foot End) − Grasp the cot frame at the foot end. Squeeze and hold the cot manual release.
8. Operator 2 (Side) − Stabilize the cot by placing one hand on the outer rail. Grasp the base frame as shown
in Figure 38. After the foot end operator has lifted the cot and squeezed the cot manual release, retract the
undercarriage with one hand and hold it in place.
9. Operator 1 (Foot End) - Release the cot manual release to lock the undercarriage in the retracted position. Ensure
that the cot manual release is released. If it is not released, the cot will not lock at the foot end.
CAUTION
To avoid the risk of equipment damage, do not push the cot into the vehicle patient compartment until the cot base is
fully retracted.
10. Push the cot into the vehicle patient compartment until the lifting arms lower and the cot locks into Power-LOAD.
11. Ensure that the cot is locked into Power-LOAD by firmly pulling on the foot end of the cot.