User Manual

IRIDIUM - Amp & IR Cab
pg 26
TIP: A simple way to check that communication is working is to send CC
#27 with a value of 127 when the FAV footswitch is off. This will turn the
FAV footswitch on if MIDI is properly connected and configured.
Turn the LEVEL knob to select
what kind of MIDI data is sent from
Iridium to other MIDI devices. Both
LEDs flash momentarily to indicate
status.
ON - GREEN
Using Iridium’s knobs and switches generates MIDI
messages that are sent out of Iridium. (Set to ON when using
MultiSwitch Plus.)
THROUGH - AMBER
Incoming MIDI messages are sent out of Iridium without any
additional MIDI messages generated by Iridium.
OFF - RED (default)
No MIDI messages are sent out of Iridium.
3
Press and hold both footswitches
while connecting power to the
pedal. Once both LEDs flash,
release the footswitches.
2
STEREO
MONO
IN OUT L OUT R EXP
SUM
USB
CABAMP
ROOM
TREBLE
BASS
FAV ON
DRIVE LEVEL
a
b
c
amp & ir cab
MIDDLE
round
chime
punch
FAV
ON
LEVEL
Configuring Iridium to Use MIDI (cont.)
Step 3 – Set MIDI Output Mode
This determines what kind of MIDI data is sent out by
Iridium. Note
that if you are only sending MIDI data to
Iridium – the most common
configuration – the MIDI Output mode must be set to OFF.
Press the ON or FAV footswitch again to set the MIDI output
channel and exit.
4
Disconnect USB from Iridium, if connected.
1