User Manual

IRIDIUM - Amp & IR Cab
pg 5
Iridium also allows for specialized use cases.
Amp processing without IR cabs
Select Iridium’s Cab Bypass mode and connect the output(s) to the
effects return or power amp input on a guitar amp.
(See page 15 for Cab Bypass mode configuration details.)
IR cab processing without amps
Select Iridium’s Amp Bypass mode and connect a preamp or preamp
pedal (such as Riverside) to Iridium’s input.
(See page 15 for Amp Bypass mode configuration details.)
Non-cab WAV files
It is possible to load any 24bit/96kHz WAV impulse response into
Iridium, including impulses of bass cabs, acoustic instrument body
resonance, samples of music, etc.
OTHER WAYS TO USE IRIDIUM
4
WARNING: Never connect the Speaker Output of a guitar amplifier
to Iridium! If you wish to use Iridium’s IR cabs with a guitar amp,
you can either use a line out from the amp or the amp’s effects
send. Note that you will still need to connect a load to the speaker
output with either of these options. You may also need to set
Iridium to Line input level.
(See page 16 for Input level configuration details.)
Connecting Iridium (cont.)