User Manual
Table Of Contents
- Strymon Flint User Manual
- Knobs and Switches
- Rear Panel I/O and Control
- Live Edit Functions
- Power Up Modes
- External Control
- MIDI Functionality
- MIDI Specifications
- Factory Reset
- Features
- Specifications
- Appendix 1: Sample Settings
- Appendix 2: Power Up Modes Quick Reference
- Appendix 3: Live Edit Controls Quick Reference
- Strymon Non-Transferable Limited Warranty
pg 16
Flint - tremolo & reverb
Power Up Modes
Spillover Mode
Setting Flint to Spillover Mode allows the wet reverb signal of a currently
selected preset to “spill” into bypass or the next selected preset�
NOTE: Because of the buffer architecture, the current preset must be active
for at least 5 seconds before Spillover between presets will be operational�
Spillover is available immediately when bypassing the effect�
1 Press and hold the REVERB ON footswitch while powering up Flint�
Once both LEDs flash, release the footswitch�
SPILLOVER
MODE
2 Turn the DECAY (SPILLOVER MODE) knob to turn Spillover Mode on
or off� Both LEDs will change color to indicate the current status as
you turn the knob�
• Spillover Mode Off: AMBER (default)
• Spillover Mode On: PURPLE
3 Press either footswitch to store the Spillover Mode status and begin
using Flint�
NOTE: The Spillover Mode setting persists across power cycles and is not
saved per preset�