User guide

- 10 -
4. Replace new Brush Assembly by fitting
the carbon head into the retaining slot
as shown.
Note: the Brass Cap of the assembly
also fits into this retaining slot - see
section 5.
Cont ...
5. Push the Brush Retaining Cap against
the spring tension and screw firmly into
place until tight, noting that the Brass
Cap of the assembly is correctly located
in the retaining slot as shown in
section 4.
Note: DO NOT OVERTIGHTEN
6. Repeat the process for the opposite site.
Cleaners, Disinfectants and Descalents
On installations where chemical disinfectants or descalents are periodically
used, the compatibility of the chemical solution regarding the pump must be
considered.
Acid based descalents and aggressive cleaning agents must not come into
contact with the pump. The pump must be removed from the system prior to the
use of these products. The system should be flushed to remove all chemicals
before the pump is re-connected.
If in any doubt as to the suitability of the chemical solutions, please contact
our Pump Assist helpline.
STORAGE
If this product is not installed immediately on receipt, store in a dry, frost and vibration
free location in its original packaging.
Fig. 8
Fig. 7
Brass Cap
Retaining
Slot
Carbon
Head