User guide

- 3 -
Pump:
Close coupled, end suction configuration and of single stage, centrifugal design.
Standard pump materials of construction of major wetted parts are as follows:
Other seal options are available. Consult Stuart Turner for further details.
LIMITS OF APPLICATION
*With footvalve fitted.
**Note: Max working pressure is the maximum pressure that can be applied to the
pump internal casing under any installation conditions.
TECHNICAL SPECIFICATION
Stuart Turner reserve the right to amend the specification in line with its policy of
continuous development of its products.
Note: For information on other voltages which are not shown, consult any
supplementary instruction sheet supplied, or the rating label attached to the
pump.
Model Body Impeller Shaft Mechanical Seal
2/50 Brass Acetal or Brass Stainless Steel Nitrile/Carbon
Ceramic/Stainless Steel
Model Impeller Voltage
Max.
Liquid
Temp.
o
C
Min.
Liquid
Temp.
o
C
Max.
Ambient
Air Temp
o
C
Max.
Suction
Lift (m)
Max. Head
(Pump Closed
Valve) (m)
Max. Viscosity
**Max.
Working
Pressure
kPa (bar)
Max. Inlet
Head (m)
Max. No.
Starts/h
(Redwood
No. 1 Scale)
Centistokes
12/50 Plastic 12 80 4 40 4.6* 13.0 50 9.5 500 (5) 38 30
12/50 Brass 12 80 4 40 4.6* 13.0 50 9.5 500 (5) 38 30
12/50 Plastic 24 80 4 40 4.6* 13.8 50 9.5 500 (5) 37 30
12/50 Brass 24 80 4 40 4.6* 13.8 50 9.5 500 (5) 37 30
Model Impeller Voltage Rating
Nominal
Motor
Speed
(r.p.m.)
Nominal
Watts
Output
(Motor)
Max. Watts
consumed at
full flow
Full
Load
(AMPS)
Starting
Current
(AMPS)
Enc.
Rating
Dims (mm)
Gross
Weight
(packed)
kg
Connections
L W H Suction Delivery
12/50 Plastic 12 Cont. (S1) 4300 160 228 19.0 170 IPX4 229 104 117 3.4 G ¾ G ¾
12/50 Brass 12 Cont. (S1) 4300 160 228 19.0 170 IPX4 229 104 117 3.4 G ¾ G ¾
12/50 Plastic 24 Cont. (S1) 4300 175 196 8.2 83 IPX4 229 104 117 3.4 G ¾ G ¾
12/50 Brass 24 Cont. (S1) 4300 175 196 8.2 83 IPX4 229 104 117 3.4 G ¾ G ¾
Cont ...