Owner's manual

- 15 -

To enable correct assembly of the cable gland the ‘O’-ring (Fig. 19 item 1) must be

placed over the cable before the clamping insert (Fig. 19 item 2) can be tightened.

Note: Cable diameter range:- 6.5 mm to 9.5 mm.

Supply Cord Extension

The pumps are fitted with a supply cord to the following specification:-

All models . . . . . . . . . . . . . . . . HO5VV-F3 G 0.75 mm² - 6 Amp rated cable.

If the supply cord is to be extended, a cord of the same specification should be used.

Any connections or junction boxes used should be specifically suited for the application

and installed in accordance with the manufacturers instructions.

Supply Cord Replacement

The supply cord and internal wiring within the terminal box are routed and

secured to ensure compliance with the electrical standard EN 60335-1. It

is essential that prior to any disturbance of this internal wiring, all cable

routing and securing details are carefully noted to ensure re-assembly to

the same factory pattern is always maintained.

If the supply cord is to be changed or is damaged, it must be replaced with a special cord

assembly available from Stuart Turner or one of their approved repairers.

On disassembly note the cord retention and routing system. Re-assemble to the same

pattern.

For information on cable connection consult the wiring diagram and cable gland fitting

instructions.

Cable Gland Fitting Instructions

Cont ...

Fig. 19