Owner manual

7
Modulation destinations for modwheel, dynamics, and pressure:
FRE1 - osc 1 frequency FRE2 - osc 2 frequency 1&2F - osc 1&2 frequency
LEV1 - osc 1 level LEV2 - osc 2 level PW1 - osc 1 pulse width
PW2 - osc 2 pulse width 1&2P - osc 1&2 pulse width FILT - filter frequency
RESO - filter resonance LEVN - noise level XMOD - xmod depth
EA1 - envelope 1 amount EA3 - envelope 3 amount EXT - external input mix level
LF1R - LFO 1 rate LF2R - LFO2 rate LF1D - LFO 1 depth
LF2D - LFO 2 depth 1&2D - LFO 1&2 depth 1&2R - LFO 1&2 rate
PAND - pan depth PANR - pan rate PAN - pan position
Modulation
Knobs
rate x2: rate of LFO.
depth x2: depth of LFO. Front panel knob controls amount of destination 1 only. You can also
use the Q dial to edit this parameter as well. Value is displayed on LFO edit page 1. Depths for
destinations two and three are done via the Q dial.
depth (xmod): depth of oscillator 2 frequency modulating oscillator 1 or filter frequency.
Each LFO can modulate up to three different destinations. If a same destination is selected in
more than one location, the location furthest left will override and determine the ultimate depth.
NOTE: Destinations 1&2 are assignable to midi controllers, destination is 3 is modulated by envelope 3.
Switches
LFO edit (Both LFO 1 and LFO 2 edit pages are the same.)
page 1: destination assignments and amounts.
page 2: [WAVE] waveform, [MODE] mono or polyphonic, [SYNC] midi clock synch times.
page 3: [KEY] key trigger modes, [QUAN] quantized LFO modulation.
Xmod: selects the destination for oscillator 2 audio frequency modulation. The front panel LEDS
will indicate the routing.
Modulation destinations for LFO 1 and 2:
FRE1 - osc 1 frequency FRE2 - osc 2 frequency 1&2F - osc 1&2 frequency
LEV1 - osc 1 level LEV2 - osc 2 level PW1 - osc 1 pulse width
PW2 - osc 2 pulse width 1&2P - osc 1&2 pulse width FILT - filter frequency
RESO - filter resonance LEVN - noise level XMOD - xmod depth
EXT - external in mix level VOL – volume