Manual

ManualsBrandsStudio Projects ManualsLarge Diaphragm MicsLarge Diaphragm Condenser Microphone

Studio Projects is manufactured and marketed under the direction of:

PMI AUDIO GROUP

USA: 1845 W. 169th Street, Gardena, California 90247

voice: (310) 323-9050 facsimile: (310) 323-9051

toll-free USA: (877) 563-6335

UK: Unit 2 Babbacombe Business Park

Babbacombe Road, Torquay, Devon TQ1 3SY

tel: +44 (0) 1803 329848

email: info@pmiaudio.com

Studio Projects

Instruction Manual

• Professional Studio Microphones

• Transformerless circuitry

• Large diameter pressure gradient capsule

employing 6 um gold sputtered Mylar diaphragms

• Low-noise FET Preamplifier

• Dual Triode “6072” hand tested tubes (T3 Only)

• Multi-Pattern variable power supply (T3 Only)

• Heavy duty road case (All Models)

• Elastic heavy duty shock mount (All Models)

visit our web site at studioprojects.com

C S E R I E S M I C R O P H O N E S

c_series_manual.indd 2-3 1/17/07 5:07:58 PM

Summary of content (10 pages)

PAGE 1
C S E R I E S M I C R O P H O N E S • Professional Studio Microphones • Transformerless circuitry • Large diameter pressure gradient capsule employing 6 um gold sputtered Mylar diaphragms • Low-noise FET Preamplifier • Dual Triode “6072” hand tested tubes (T3 Only) • Multi-Pattern variable power supply (T3 Only) • Heavy duty road case (All Models) • Elastic heavy duty shock mount (All Models) Studio Projects is manufactured and marketed under the direction of: PMI AUDIO GROUP USA: 1845 W
PAGE 2
StudioProjects 2 INSTRUCTION BOOK CONTENTS What is Studio Projects?...................................................................................................2 Guidelines For Proper Care/Use ......................................................................................2 Electrical Features…........................................................................................................3 Operation………………………………………………….................................................
PAGE 3
StudioProjects 4 OPERATION C1 Using a male to female 3-pin XLR cable, plug microphone in to gain device (preamp, mixing console, etc.), making sure that +48-volt phantom power is active and gain is not at a level sufficient to cause ear-splitting feedback through monitor speakers. Address microphone from the side (not the top of the grill) above the SP logo badge. If bass cut is required, select one of two featured high pass filters.
PAGE 4
StudioProjects 6 www.studioprojects.com TROUBLESHOOTING TIPS cont... C1 Shockmount Looks As If It Should Fit On Mic Stand, But For Some Reason, It Will not Screw On: There are two standard thread sizes for mic stands, 5/8-27 and 3/8-16. Studio Projects shockmounts ship with a brass reducer installed, which allows for the 3/8-16 threads. For use with 5/8- The Studio Projects C1 is an externally polarized cardioid pressure gradient transducer microphone with FET impedance converter.
PAGE 5
StudioProjects 8 www.studioprojects.com C3 T3 The Studio Projects C3 is an externally polarized cardioid pressure gradient transducer microphone with FET impedance converter. Diaphragm material is 6µm mylar for natural reproduction of vocals and instruments. It features a selectable pad and high pass filters as well as three directional pattern settings: omnidirectional, cardioid and figure of eight. The output circuitry is active and is capable of driving long cable runs.
PAGE 6
10 StudioProjects www.studioprojects.com C4 LSD2 The C4 is a 20mm diameter condenser microphone featuring interchangeable capsules, linear, low-noise, solid-state electronics, selectable -10dB/20dB pads and selectable 150Hz/75Hz high pass filters. It is intended for all-around use on stage, on location and in studios of all calibers. The LSD-2 is a stereo microphone comprised of two separate dual-membrane solid state microphones contained within a single housing.
PAGE 7
STATEMENT OF ROHS COMPLIANCE PMI Audio Group manufactures complete electronic products which are covered by the European Union’s “Removal of Hazardous Substances” directive 2002/95/EC (RoHS). This directive seeks to eliminate toxic substances from the manufacturing process, such that when equipment is disposed of at the end of its life cycle, the materials it contains do not contaminate the environment and pose health risks.
PAGE 8
NOTES NOTES c_series_manual.
PAGE 9
STUDIO PROJECTS LIMITED WARRANTY DISCLAIMER OF WARRANTY T H I S P R O D U C T I S F O R P R O F E S S I O N A L U S E O N LY ALL OTHER WARRANTIES, EXPRESS OR LIMITED, INCLUDING, BUT NOT LIMITED TO ANY/OR ALL IMPLIED EXCEPT FOR THE FORGOING WARRANTIES, PMI HEREBY DISCLAIM S AND EXCLUDES WARRANTIES OF MERCHANT ABILITY, FITNESS FOR A PARTICULAR PURPOSE AND/OR ANY WARRANTY WITH PMI Audio Group warrants that all products will be free from defects in material or workmanship: REGARD TO ANY CLAIM OF INFRINGEM
PAGE 10
Zip Code: 1845 W.