Instruction manual

Instruction manual VMK-149plus/VMK-188plus
15
buttons
PROCEDURE: BUTTON PROGRAMMING
We will set up a BUTTON to behave like a simple ON/OFF switch, or Latch Switch. Press the BUTTON once and the
Switch will be on. Press the BUTTON again and the Switch will be off. Programming Transport BUTTONS follows the
exact same procedure.
TIP: This can be very useful to control the Mutes on your Audio/Sequencing program. Most Pro and Semi Pro
Audio/Sequencing programs will allow you the option to control various functions of the program from an external
controller, in this example, controlling the Mutes on your virtual mixer. (See your Program’s manual for details.) Each
BUTTON can behave like a Latch, used in this Mute example (SWITCH MODE), or like a Momentary (PUSH MODE)
switch. A Momentary switch will only function when the BUTTON is held down. This is very useful for the Fwd BUT-
TON and Rew BUTTON in the Transport section.
1) PRESS EDIT
2) PRESS BUTTON
In this example Move SLIDER 1
w/Bank A Selected
(Remember: keep track of
your BANKS when programing!)
3) PRESS PAGE UP
In this example we’ll use
CTRL Change number 10.
You may adjust this to any
CTRL number you desire.
4) PRESS PAGE UP
Set the Key Note to 60.
Key range is 0-127
5) PRESS PAGE UP
SWITCH: Press button once,
a NOTE ON Message will transmit.
Switch is ON.
Press button again, a NOTE OFF
Message will transmit.
Switch is OFF.
PRESS OR MOVE
ANY CONTROLS
SCREEN
CHANGE
EDIT SLIDER 51
MIDI CHANNEL OFF
SCREEN
CHANGE
To adjust the Midi Channel use the DE knob
EDIT BUTTON: B1
CTRL CHANGE: OFF
SCREEN
CHANGE
To adjust the CTRL Change use the DE knob
EDIT BUTTON: B1
CTRL CHANGE: OFF
SCREEN
CHANGE
To adjust the Key Note use the DE knob
EDIT BUTTON: B1
KEY NOTE: SWITCH
SCREEN
CHANGE
To adjust the Key Note use the DE knob
Press BUTTON (1)