Installation Guide

Installation
1: Install the spout body:
a) Fit the O-ring into the groove on the underside of the spout body.
b) Then insert the spout body into the centre hole on the basin from above.
c) Tighten the rubber washer, the metal washer & the fixing ring with the mounting screw from the under-side of the basin.
Check that the spout body is correctly positioned, and then fully tighten the fixing ring and the mounting screw.
d) Screw on the three-way connector at the tail of spout body.
2: Install the hot and cold water valves:
a)Fit the washer into the groove on the underside of both tap valves.
b)Screw the flexible hoses into the valve body, and fully hand tighten.
c)Insert the two valve bodies into left and right holes on the basin.
d)Tighten the rubber washer, the metal washer & the fixing ring with the mounting screw from the under-side of the basin.
Check that the valve body is correctly positioned, and then fully tighten the fixing ring and the mounting screw.
3: Use two hoses to connect the three-way connector with both left and right valve bodies.
4: Connect the water supply pipes to the tail of flexible hoses with “hot” & “cold” indicator, with the hot water on the left and
cold water on the right.
5:
Put the pop-up waste through the hole from the top of the basin，then fix the rubber washer and retaining screw in turn.
Twist the pipe to the bottom of the waste by thread，and then tighten the whole set in position.
NOTE:
Please make sure making the bottom side of the regulator
towards the connector port.
Dimensions
Unit:inches
Hot switch valve (Red)
Mixer body
Fixing ring
Mounting screw
Hose
Three-way connector
Cold switch valve (Blue)
Flexible hoses
Rubber washer
Metal washer
Washer
O-ring
Pop-up Waste
Ø1.38 ″
2-M10X1
Ø1.38 ″
Ø1.38 ″
max
1.18″
1.44″
4.06″
1.81″
4.53″
3.99″
4.80″
3.94 ″ 3.94 ″