Installation Guide

ASSEMBLY INSTRUCTIONS

IS08812-I

Hardware Used

4. Fasten the other side panel (A) with screws (BB)

and wood screws (CC), as shown.

Screw

x 3

Wood Screw

x 4

Allen Wrench

x 1

Hardware Used

5. Hold the unit level at the desired position on

the wall. Mark the mounting points on wall

through the holes in the back tubes of the unit.

NOTE: Make sure the unit is level.

NOTE: Wall anchors (GG) should be oriented

with the at side horizontal.

Hammer the wall anchors (GG) into wall, unless

mounting screws (EE) will go directly into a stud.

Insert the mounting screws (EE) through the

holes in the back tubes and the spacers (FF)

of the unit.

Place unit against the wall, lining up the mounting

screws (EE) to the holes in wall and complete

the mounting by tightening mounting screws (EE)

into the studs or wall anchors (GG), as shown.

Wall Anchor

x 4

Spacer

x 4

Mounting Screw

x 4

wall mounting hole