Installation Guide

GLUE-DOWN INSTALLATION INSTRUCTIONS

5. For rst plank of second row, angle plank up

slightly, push forward to interlock the side

tongue, then slide plank to the left to align the

edges of the end joint. Carefully push plank

down until tongue and groove lock together.

A slight tap with a tapping block (not included)

may be necessary to complete the interlock.

Note: Begin the second row with the cut piece

from the rst row. If the cut piece is shorter than

8 in., begin with a new plank that exceeds 8 in. in

length and allows 6 in. spacing between the end

joints.

4. Overlap the end joint of second plank onto the

board previously installed. Continue placing

succeeding planks to complete row.

Note: The last plank of the rst row may have to be

cut to size.