Installation Guide

13
GLUE-DOWN INSTALLATION INSTRUCTIONS
6. Install the second plank of the second row by rst
interlocking the end followed by the side. Slightly
angle the edge to properly engage the tongue and
groove then push down. A slight tap with a tapping
block may be necessary to complete the interlock.
7. Repeat steps 1-2 then 5-6 to install remaining
planks in remaining rows.
Note: Whenever practical, use cut pieces from
previous rows as a starter plank to reduce waste.
Maintain 8 in. spacing between end joints after the
rst four rows for best appearance.
3
2
1
6
7
8 in. minimum
end joint stagger
8 in. minimum
end joint stagger