Installation Guide

9
FLOATING INSTALLATION INSTRUCTIONS
9. When installing last row of planks, use a pull bar
(not included) to draw the last row to t tightly
into previous row.
8
a. Measure the distance between the oor face
edge (exclude the tongue) to the wall. Subtract
the expansion space from this measurement for
expansion gap. Draw a line on the planks. Cut the
planks
using an electric circular saw with nish saw
blades (not included)
along the marked line.
Note: The blade should cut into the face of the board
to prevent splinters. Care must be taken to prevent
scratching the face of planks.
1
Expansion
Space
8a
2
1
9
1
Expansion
Space
8b
8b. Place the row of planks to be t on top of the last row
of installed planks. Use a piece of plank as a scribe to
trace the contour of the wall.
Then, remove and cut the
planks
using an electric circular saw with nish saw
blades (not included)
along the marked line.
Note: The blade should cut into the face of the board to
prevent splinters. Care must be taken to prevent scratching
the face of planks.
Most often, the width of the entire length of the last row
will need to be cut (ripped) so it is narrow enough to t the
remaining space. To nd the correct measurement use
either: