How to Guide

7 shawfloors.com | 1-800-411-7429
STEP 14
Connect the planks in the following rows by
aligning the end seam of each plank directly
above the end seam of the preceding plank. Insert
the long side seam at a sight angle first and as the
top surface meet, rotate the plank down into the
locked position. Make sure to apply a s-bead of
adhesive to the back of all planks and firmly place
the plank to the wall. Then using the brad nailer
shoot a nail through the groove edge of every
plank into the wall studs.
STEP 15
The last row of the laminate may need to be cut.
Measure the distance between the floor/ceiling
to the last row of laminate that was installed and
using a table saw or jig saw cut the laminate to the
width desired.
METHOD A - Floor to Ceiling Installation (cont.)