How to Guide

9 shawfloors.com | 1-800-411-7429
METHOD B - Wainscot Installation
STEP 1
Remove existing baseboards on the wall that will
be receiving the laminate.
Photo of baseboards being removed.
STEP 2
Remove any electrical outlet and light switch
covers. Take care not to touch any exposed wiring.
Make sure to turn o the power supply while
working around exposed power outlets or light
switches.
Photo of electric outlet being removed.
STEP 3
Mark all studs using a stud finder and then using a
chalk line from top to bottom, mark the studs.
Photo of stud finder being used; photo of chalk
line being marked.
STEP 4
Measure to determine the desired length of the
planks. Make sure to allow for a ½ expansion
between the floor and the laminate.
Photo of plank being measured to standard
wainscot length.