Installation Guide

transolid.com

10. If needed, place 1/16 in. thick shims at the base

of the left side panel (C) and right side panel (D)

installation site. Trial t the left side panel (C)

and right side panel (D) on the shims and use a

sanding block if any ne adjustments are

needed. Clean the back of the left side panel

any other area that will be in contact with the

silicone adhesive (K) with denatured alcohol and

a clean rag (not included).

11. Cut twenty-two 4-in. strips of installation tape (M)

and place them around the perimeter of left side

panel (C) and right side panel (D), 2 in. from the

edge and approximately 6-7 in. apart. Apply

silicone adhesive (K) in 3/4 in. diameter dots

every 6-7 in. apart over the back surface of the

left side panel (C) and right side panel (D). Apply

a thin bead of silicone adhesive (K) in the corner

of the back wall assembly. Place left side panel

rmly. Clean up any excess silicone adhesive (K)

with denatured alcohol while the silicone

adhesive (K) is still wet.

12. FRONT EDGE TRIM

Apply a continuous bead of silicone (K) along

the front edge of left side panel (C) and right

side panel (D), approximately 1/4 in. from the

edge. Attach the front edge trims (E) to the front

edges of left side panel (C) and right side panel

(D) and press rmly to secure in place.

Note: Use masking tape (not included) or

optional wood bracing to hold the front edge trim

in place while the silicone adhesive (K) cures.

ASSEMBLY INSTRUCTIONS