Installation Guide

5
Lowes.com
ASSEMBLY INSTRUCTIONS
6
6. Trial t the upper back panel (B) on top of the
lower back panel (A) and use a sanding block
(not included) if any ne adjustments are needed.
Remove upper back panel (B) from the wall and
clean the back of the upper back panel (B), the
wall board and any other area that will be in
contact with the silicone (K) with denatured
alcohol and a clean rag (both not included).
4
4. Cut twelve 4-in. strips of installation tape
(M) and place them on lower back panel (A) where
indicated in gure 4. Apply silicone adhesive (K) in
3/4 in. diameter dots every 6-7 in. apart over the
surface of the reinforcement strips on the back
of lower back panel (A). Place the lower back panel
in place and press rmly.
A
KM
I
M
K
A
B
5. UPPER BACK PANEL
Determine the width of the upper back wall panel
(B) by measuring from the top of the lower back
panel (A) and 36 in. up from the top of the lower
back panel (A). Repeat steps 1 and 2 for upper
back panel (B), noting the 1/4 in. extension on
upper back panel (B) is at the bottom.
5
A
36 in.
Measure
Glue
Side
Finish
Side
Bottom
B