Installation Guide

6
Lowes.com
7
7. Cut twelve 4-in. strips of installation tape (M)
and place them on upper back panel (B) where
indicated in gure 7. Apply silicone adhesive (K) in
3/4 in. diameter dots every 6-7 in. apart over
the surface of the reinforcement strips on the back
of upper back panel (B). Apply a bead of silicone
adhesive (K) into the area where the lower back
panel (A) and upper back panel (B) connect.
Place the upper back panel (B) into the lower
back panel (A) and press rmly together and
against the substrate.
A
B
K
M
K
M
ASSEMBLY INSTRUCTIONS
K
C
8. SIDE PANEL
Measure from the back wall at the top and the bottom
of the back panel assembly to the edge of the shower
base. The front edge trim (E) extends the left side
panel (C) and right side panel (D) width by a
minimum of 1/2 in. to a maximum of 1-1/2 in., so
the left side panel (C) and right side panel (D) width
needs to be cut a minimum of 1/2 in. shorter than
your desired nished side wall dimension. Note: If the
wall is not square, you can use cardboard to create
a template of the wall and transfer the data to the
left side panel (C) and right side panel (D). Be certain
to use left side panel (C) on the left side of the
installation site and right side panel (D) on the right
side to ensure proper tile pattern layout.
8
C
D
9
9. If no plumbing holes exist on side panel, proceed to
step 10. Locate the locations of the plumbing holes
and transfer the data to either left side panel (C) or
right side panel (D). Cut the holes a minimum of 1/4
in. larger than the pipe diameters. Note: To avoid
possible breakage, all inside corners of cutouts
should have a minimum 1/4 in. radius. Use masking
tape (not included) to protect the area where the
cutting tool will contact the nished surface.
C
D
Finish
Side
Glue
Side