Installation Guide

Adhere the plank to the wall leaving a 3/16" gap (A) from the corners of
the wall and a 1" gap (B) at bottom. Drive brad nails ½" from the top and
bottom of each plank to secure to wall. Place nails where the trim will
cover.
Continue with the installation for each subsequent plank by  rst applying
silicone adhesive to the back side of the plank in an “S” pattern. Then
angle the groove over the tongue of the previous plank and wiggle into
place. Tighten joints as needed with a tapping block or pull bar. Finally,
drive brad nails ½” from the top and bottom of each plank to secure to
wall. Place nails where the trim will cover. Be sure to drive the brad nails
into a stud whenever possible. (Figure 4)
Finish wainscot accent to ending wall. (Figure 5)
Install trim (chair rail) over the top edge. Install quarter round in the
corners. Finish by installing the baseboard of your choice. (Figure 6)
1" Gap
A
Level Line
3/16"
Gap
4
3/16"
Gap
3/16"
Gap
5
Base Detail
Matching Incizo
®
Molding
Square Nose Application
Wainscot Accent
Laminate
F l o o r
6
Quarter round
3
Silicone in
“S” pattern
Apply silicone adhesive to the back side of the plank in an “S” pattern. If
you’re using a laminate plank with an attached pad, apply the silicone
directly to the pad on the back of the plank. (Figure 3)