Installation Guide

PREPARATION

HARDWARE CONTENTS

Part Description Quantity Picture (Shown to size)

2 1/2 inch Screw 4

2 in. Screw 4

1 in. Screw 2

Knob 2

Screw Plug 4

Flat Washer 1

Hook 1

Before beginning installation of product , make sure all parts are present. Compare parts with

package contents list and diagram above. If any part is missing or damaged, do not attempt to

install the product. Contact customer service for replacement parts.

Approximate Installation Time: 45 minutes

Tools Required for Installation: Pencil, Safety Goggles, Phillips Screwdriver, Drill,

Tape Measure and Circular Saw

Page 3

INSIDE MOUNT INSTALLATION INSTRUCTIONS

Measure the “inside” width and height dimension of your desired shutter installation. Compare

your installation size to the size of the shutter set you purchased. The overall width of your

shutter set includes the shutter panels (A), 2 hanging strips (B) and 16 filler strips (C).

For insi de mount ing our fille r strips (C) are an incredibly easy way to adjust the width of the

shutter set, without having to use a saw. E ach filler strip (C) is 1/8 in. thic k. To reduce the

overall width of the frame set by 1/8 in., simply peel off 1 filler strip (C). With the 16 filler strips

simply snap back into place.

Step 2: (Fig. 2)

Hang th e shutt er pa nels (A) ont o the hanging

strips (B).

Opt ional: In stall knob (DD) and hook (GG) set

using the 1 in. screw (CC) and flat washer (FF).

Hardware Used

Screw Plug x4

Fig. 1

Fig. 2

2 1/2 in. Screw x4

Step 1: (Fig. 1)

Install hangin g strips (B) into the window jam b

using the pro vided 2 1/2 in. screws (AA). Filler

strips (C) , if needed, fit between the hanging

strip (B) and window jamb .

Push screw plugs (EE) into screw hole until flush

with surface of hanging strip (B).

IMPOR TANT - Always use a proper anchoring

device (not included).

NOTE - All shutters can be shortened prior to

installation. See page 6 for instructions.