Instructions / Assembly

Assembly Instructions
ITEM PART DESC. QTY ITEM PART DESC. QTY
A Table top 1 F Bolts Ø6*30MM 10
B Wooden leg 2 G Bolts Ø8*30MM 4
C
Wooden
supporter
2H
Allen wrench
(smaller)
1
D Wooden base 1 I Allen wrench 1
E Flat washer 14 J Bolts Ø6*40MM 2
STEP ONE
STEP TWO
STEP THREE STEP FOUR
Laying out all the parts and hardware and identifying
each part as shown may help you when you assemble
the console table.
Attach wooden base to the end of leg
with bolts "G" , flat washers and Allen
wrench "I".
Finish product.Please make sure all the
bolts are fully tightened before using this
table.
Put the table top upside down on soft & clean
surface. Attach metal leg to the bottom of the table
top with bolts" F ", flat washers and Allen wrench
"H" as shown above. Please don't fully tighten bolts.
Attach wooden supporter to the unit with
bolts "F" "J", flat washers and Allen wrench
"H".Please don't fully tighten bolts.
F
J
G
E
E
E
F