Use and Care Manual

18 19

Attaching the Top Corner Panel to the Mantel

Place the Back Panel Brackets (GG) between the Back

Panel (K) and the grooves of the assembly as shown.

Insert Bolts (DD) through the holes in the pre-attached

connector block on the end of Corner Support (M) to

attach to the Top Corner Panel (L) and tighten with a

Phillips screwdriver.

Fasten each Back Panel Bracket (GG) using Screws

(FF). Repeat until all brackets are in place as indicated

by the diagram.

Insert Bolts (DD) through the holes in the pre-attached connector blocks along the long edge of the Top Corner Panel (L) to

attach the Top Corner Panel to the Top Panel (G) and tighten with a Phillips screwdriver.

Securing the Fireplace Background

Attaching the Support to the Top

Corner Panel

Assembly (continued)