Installation Guide

Place the Top Panel (G) on top of the main assembly while aligning the pre-installed screws on the edges of the main assembly

with the pre-drilled screw holes on the Top Panel (G).

After inserting the screws (BB) into the holes, tighten the fasteners from underneath the Top Panel (G) using a Phillips

screwdriver as shown.

Place the Back Panel Brackets (LL) between the back

panels and the grooves of the assembly as shown.

Fasten each Back Panel Bracket (LL) using Screws (KK).

Repeat until all brackets are in place as indicated by the

diagram.

Each Door Handle (NN) has pre-attached screws.

Remove these screws and place the Door Handles

(NN) over the predrilled holes in the Left and Right

Doors (K and L).

Place the pre-attached screws on the other side of

the Left and Right Doors (K and L) and tighten with a

Phillips screwdriver through the door and into the Door

Handles (NN).

Securing the back panels

Attaching the door handles

Attaching the top panel

Assembly (continued)