Installation Guide

Securing the log set

Assembling the replace

Route the wires of the Log Set Left (EC) and the Log Set Right (ED) down the back of the Ember Bed (EG) and into the

receiving tabs to secure in place. Refer to the lower diagram.

Place the assembled log set (EG) into the back of the

unit behind the glass panel.

Push the tabs beneath the log set into the holes on

the bottom panel.

Gently plug the cords from both the Log Set Left (EC) and the Log Set Right (ED) into the ports as shown. Ensure the cords are

plugged in straight.

Once the log set is in place, secure with Screws (DD)

through the bottom of the log set and into the base.

Assembling the log set

Assembly (continued)