Installation Guide

16
26
Installing the tipping restraint hardware
WARNING:
Installing the Tipping Restraint
Hardware will help prevent accidents or damage to the
unit.
Assembly (continued)
WARNING
• Unit must be placed on a level surface
or leveled with included hardware (when
applicable).
• Do not sit or stand on or allow children to
climb, sit or stand on the assembled product.
• For safety reasons, it is imperative that this
unit be mounted to the wall or oor.
• Unit can tip over causing severe injury or
death.
• Do not exceed the recommended weight
limits.
• Before cutting, drilling or hammering into
any wall or oor surface, verify the location
of electrical, plumbing and gas lines. Cutting
may cause serious injury.
BB
Wall
NOTE:
Installation of the Tipping Restraint Hardware (BB)
will provide a small space between the wall and the unit.
This will allow you to run power cords and connector cables
to your television or other devices placed on top of the unit.
When the Tipping Restraint Hardware (BB) is properly
installed, it can provide protection against unexpected
tipping of the unit due to small tremors, bumps or
climbing.
Each Tipping Restraint Hardware (BB) includes one Unit
Anchor, one Wall Anchor, one Anchor Tether, and two
Anchor Screws. Use these to complete the following
steps for a proper installation.
Locate a secure wall stud behind the unit closest to the
left side.
Align the Unit Anchor with a wall stud and attach with
Anchor Screws using a Philips screwdriver. The Anchor
Screws must pass through the Top Assembly (G) for
proper installation.
Align the Wall Anchor in the center of the wall stud,
at level with the Unit Anchor, and attach with Anchor
Screws using a Philips screwdriver.
On the Anchor Tether, detach the cable from the
connector and loop the loose cable through the eyelets
on the Wall Anchor and Unit Anchor. Reattach the loose
cable to the connector, but do not tighten.
Locate a secure wall stud behind the unit closest to the
right side, and repeat the steps above.
Tighten both Anchor Tethers by pulling the cable
through the connector.