Instructions / Assembly

7 H
OMEDEPOT.COM
Mai
ntenance
□
□
□
□
□
Che
ck all screws and nuts periodically for tightness, fastening them again as required.
Disassemble the product in the reverse order of the assembly steps.
Always disassemble the product completely. A partially-disassembled product is not stable enough to sit on, and therefore can be damaged or
cause injury.
For cleaning, use water or mild detergent. Do not use solvent-type cleaning agents.
Periodically (every 90 days) make sure that the screws are fully tightened.
Care and Cleaning
□
□
□
Fo
r washing the seat, use water or mild detergent. If there is solvent on it, clean with a dry cloth and water.
Does not use bleach, acid, or other abrasive cleaners on the frame parts.
Metal components of indoor furniture are treated with powder coating. Surface oxidation (rusting) will occur if the coating is scratched. To
minimize:
□ It is recommended that care be taken when assembling and handling the product in order to prevent the paint from being scratched.
□
□
Surface rust can be removed easily using a very light application of common cooking oil.
If surface oxidation (rusting) occurs and no measures are taken to correct it, the oxidation may start dripping onto the assembly surface,
which may cause damaging stains that may be difficult to remove.
Troubleshooting
Pl
ease contact 1-877-527-0313 for further assistance.
PROBLEMS
SOLUTION
Leg not fit into the seat /
wobbly/ not level.
If not level please turn the pin at the bottom of the front legs to
m ake chair level.
Place the chair on a level surface then check if all screws tighten up to
100%.
If they are wrong, re-assem ble according to the correct part label on
the Instruction Runner.
According to the parts label on the Instruction Runner, check if the
front / back / right / left leg is corret.