Installation Guide

Stop position alteration
If you want the shade stop at a lower position
2A1A
Just remove the stop end plug square pin end from the
bracket. Keep the opposite end of the roller on the
bracket and avoid removing from the bracket
Unroll the shade down to the required position by
hand evenly, then replace the square pin end on the
bracket
3A
If you want the shade stop at a higher position
1B
2B
Just remove the stop end plug square pin end from the
bracket. Keep the opposite end of the roller on the
bracket and avoid removing from the bracket
3B
Roll up the shade to the required position by hand
evenly, then replace the square pind end on the
bracket.