Full Product Manual

Assembly

Attach the stretchers (D) and (C) to the side frame (B) with bolts (AA).

Tighten with Allen wrench (CC) after all bolts are completely

lined up and inserted into the holes.

Attaching the stretchers Attaching the side frame

Attach the side frame (B) to the stretchers (D) and (C) with bolts (AA)

and tighten with Allen wrench (CC).

Tightening all the bolts

Attaching the table top

Put the table on the level surface and fully tighten all bolts previously

installed with allen wrench. Tighten all the bolts on a level surface.

Put the table top (A) on a soft, smooth surface and attach the metal

frame to the back of top with screws (BB).

Use a Phillips screwdriver (not included) to tighten the screws.

NOTE: If the table legs are not on the oor.

You can adjust levelers properly (on the bottom of legs)

You may need to loosen the bolts. Apply some weight on

the table to get all legs on the oor and then tighten the

bolts at that positon.