Manualshelf

User's Manual

ManualsBrandsStyling city industries ManualsElectronicsWireless Doorbell Receiver w/ Analog Clock
1234
Door Chime Operation
Press the button on the Push Button unit once, it sends a wire free signal to the Wall Clock Door
Chime, the Chime unit will sound. The sound will stop as soon as the melody ends. For repeat sound,
press the button again. Hold the button in will NOT repeat the sound.
Sound Volume Adjustment
Tone sound volume control can be adjusted to high or low. The high-low switch is located at the back
of the Wall Clock-Door Chime unit.
Clock Adjustment
Adjustment switch is located at the back of clock unit, rotate it to clockwise or anti-clockwise to get
the correct time.
Important
1. Do not mount the Push Button onto any metal surfaces or UPVC doorframe, as this will reduce
the operation range seriously.
2. Do not expose either unit directly to rain or immerse in water.
3. Do not mount either unit close to fireplace or expose to high temperature.
4. Do not drop either unit or subject to excessive blows.
5. Do not use different type if batteries, or mix up old and new batteries.
6. Always use alkaline batteries as these will give longer service and are less likely to leak.
7. If leaving the doorbell for long period of time, remove the battery from compartment to prevent
leakage.
8. Door Chime unit is designed for indoor use only.
9. Please dispose of old, defective batteries in an environmentally friendly manner in accordance
with the relevant legislation.
10. Make sure that no naked flame sources, such as lighted candles, should be placed on the unit.
11. The unit should not be exposed to dripping or splashing and that no objects filled with liquids,
such as vases, shall be placed on the unit.
12. CAUTION: Replace only with the same or equivalent type of batteries that are recommended by
the manufacturer.
13. CAUTION: Danger of explosion if battery is incorrectly installed or replaced.
Trouble Shooting & User Hints
Problem Possible Cause Suggest Remedy
Chime does not 1. Units are out of range 1. Operate the Chime unit within
sound but LED (max. range 30M) the operation range (30M)
lights on Push 2. Push Button and Chime units 2. Re-set the frequency digital code
Button are not on same digital code (see Digital Code Set Up)