User's Manual

Chime does not 1. Flat Push Button battery 1. Change the battery
sound plus no 2. Wrong polarity of battery 2. Re-insert battery as internal
lights on Push in Push Button marking in right polarity
Button LED
Chime sounds 1. A similar Wire Free Door 1. Change the frequency digital code
without Push Chime product is operating (see Digital Code Set Up)
Button being nearby on the same frequency
pressed digital code
Important: There are no serviceable parts in the units, do not attempt to repair it.
Specification
A. Push Button unit
Power : 1 x 3volt CR2032 Lithium battery (included)
Consumption : 2.0mA - ON
0.001mA – OFF
B. Wall Clock with built-in Door Chime unit
Power :
a) Wall Clock: 1 x 1.5volt alkaline battery (“AA”, UM3 & LR6 – not supplied)
b) Door Chime: 2 x 1.5volt alkaline batteries (“AA”, UM3 & LR6 – not supplied)
Operating Temperature : -10C – +40C
Operating Distance : 30metre (100ft approx.) in open field
Selectable Tone : Total 8 selectable melodies
Selectable Digital Code : Total sixteen (16) possible digital codes
Instruction to the User
This equipment has been tested and found to comply with the limits for a class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications.
The user is cautioned that changes and modifications made to the equipment without the approval of
manufacturer could void the user’s authority to operate this equipment.