User's Manual

Important
1. Do not mount the Magnetic Switch Transmitter onto any metal surfaces or UPVC doorframe, as this
will reduce the operation range seriously.
2. Do not expose the Magnetic Switch Transmitter directly to rain or immerse in water.
3. Do not mount the unit close to fireplace or expose to high temperature.
4. Do not use rechargeable battery.
5. Do not leave exhausted batteries in either unit. If leaving the PIR Sensor Transmitter for long
periods, remove the battery from compartment to prevent leakage.
6. Always use alkaline battery as it will give longer service and are less likely to leak.
7. The Magnetic Switch Transmitter is designed for indoor use only.
8. Please dispose of old, defective batteries in and environmental friendly manner in accordance with
the relevant legislation.
9. Make sure that no naked flame sources, such as lighted candles, should be placed on the unit.
10. The unit should not be exposed to dripping or splashing and that no objects filled with liquids, such
as vases, shall be placed on the unit.
11. CAUTION: Replace only with the same or equivalent type of battery that recommended by the
manufacturer.
12. CAUTION: Danger of explosion if battery is incorrectly installed or replaced.
Specification
Power Supply : 1 x 9volt battery (not included)
Detection : For window or door (indoor use only)
Operation Temperature : -10 C – +40 C
Operation Distance : 30metre (100 ft)
Selectable Melodies : 8 melodies
Selectable Channel : Total sixteen (16 possible coded frequency)
Instruction to the User
This equipment has been tested and found to comply with the limits for a class B digital device, pursuant
to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications.
The user is cautioned that changes and modifications made to the equipment without the approval of
manufacturer could void the user’s authority to operate this equipment.