Fitting Instructions

Remote Control Light Socket
Model: WRC-102
The Remote Control Light Socket consists of two separate units: -
1. Remote Control Unit (Transmitter)
2. Light Socket Unit (Receiver)
These units are completely self-contained and no wiring between them is necessary.
Fitting Instructions
It is important to install this product in accordance with the fitting instructions below. Failure to do so
may render your guarantee void.
IMPORTANT: PLEASE RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE WHEN
REPLACING BATTERIES
1) Before commencing work, you will require a drill and cross-headed screwdriver.
2) 1 x 3.0v batteries (CR-2032 – included)
3) 1 x E26 – 60W Li
ght Bulb
4)
Av
oid positioning on UPVC or Metal Frames.
5) Avoid positioning above heat sources such as radiators or in damp areas such as a kitchen or
bathroom.
Fixing screws and wall plugs are supplied with this kit.
Pressing the Remote Control sends a wireless signal which activates the Light Socket. The
operating range is 30-50m (99-165ft, indoor) and you can use the Light Socket virtually anywhere in
the home. However, the transmission range will be reduced if the signal is transmitted through a
number of walls or ceilings and Metal partition can also reduce the operating range.
IMPORTANT: Before you drill any holes in the wall, please make sure there are not any cables or
pipes that you may accidentally damage.
Remote Control unit - Battery Installation
Remote Control uses 1 x 3volt CR2032 Lithium battery (included), to activate remove the isolation
strip.
To replace slide open the compartment at the back and replace ensuring correct battery polarity.
Light Socket unit
Light Socket unit is powered by A/C mains power (100-110volt ~ 60Hz). Screw the unit into any
convenient Light socket. The Light Socket is now ready to learn the operation code (Please see
Digital Code Set Up).