Fitting Instructions

Installation Guide

To install you will require a drill and cross-headed screwdriver.

Remote Control Unit

Hang using the two holes at the back of Remote Control.

Mounting on any metal surfaces will reduce the broadcasting range.

Light Socket Unit

Screw the Light Socket unit into any light socket. Avoid positioning above heat sources (e.g. radiator)

or in damp areas such as a kitchen or bathroom. Screw in a E26 - 60W (or any equivalent) light bulb

Important: Test the Light Socket to ensure unit is within operating range.

Digital Code Set Up

The Remote Light Socket kit is equipped with advanced random and self-learning operation code

ability.

1. First time operation (1

bell push):

After battery installation on Remote Control and Light Socket unit is powered, Red LED on the

Wall Socket lights up, press the Remote Control unit once, The Red LED will blink to indicate

that a new operation code is registered and memorized.

2. 2

Remote Control: Then press and hold the Code Setting button (on the side of Light Socket

unit) for about 1 second, the Red LED on Light Socket unit will light up to indicate that it is ready

for the new code registration. Press the 2

Remote Control once (within 10 seconds) to

generate a new operation code randomly and send a wireless signal to the Wall Socket unit, Red

LED will blink to indicate that a second operation code is also registered and memorized.

3. Repeat the same procedure (pt. 2) for 3

and 4

Remote Controls.

4. Erase the Memorized Operating Code: Unscrew the Light Socket, press and hold the Code

Setting Button for 5 seconds when re-power the Light Socket, the Red LED will flash to indicate

that it is ready to learn the new set of operating code.

IMPORTANT: Erase the Light Socket operating code and repeat the code setting procedure after

the Remote Control CR2032 battery has been replaced.

NOTE: If the Light Socket operated for no reason, it is indicated that it has been interfered by other

similar Light Socket unit nearby, reset the digital code by remove the power supply from both units

and erase the digital code as stated on point (4) then repeat the digital code setup procedure.

Light Socket Operation

Press the button on the Remote Control unit once, it sends a wireless signal to the Light Socket and

Red LED will blink once, it turn power on and light up the light bulb that is connected onto it.