Fitting Instructions

Remote Control Unit
Hang using the two holes at the back of Remote Control. Mounting on any metal surfaces will reduce
the broadcasting range.
Wall Socket Unit
Plug the Wall Socket unit into any convenient wall socket. Avoid positioning above heat sources (e.g.
radiator) or in damp areas such as a kitchen or bathroom.
Connect the lights, TVs or small electrical appliance with the Wall Socket Unit, with wattage not more
than 1,100watt or 10amp.
Important: Test the Wall Socket to ensure unit is within operating range.
Digital Code Set Up
The Remote Wall Socket kit is equipped with advanced random and self-learning operation code
ability.
1. First time operation (1
st
bell push):
After battery installation on Remote Control and Wall Socket unit is powered, Red LED on the
Wall Socket lights up, press the Remote Control unit once, The Red LED will blink to indicate
that a new operation code is registered and memorized.
2. 2
nd
Remote Control: Then press and hold the Code Setting button (on the side of Wall Socket
unit) for about 1 second, the RED LED on Wall Socket unit will light up to indicate that it is ready
for the new code registration. Press the 2
nd
Remote Control once (within 10 seconds) to
generate a new operation code randomly and send a wireless signal to the Wall Socket unit, Red
LED will blink to indicate that a second operation code is also registered and memorized.
3. Repeat the same procedure (pt. 2) for 3
rd
and 4
th
Remote Controls.
4. Erase the Memorized Operating Code: Unplug the Wall Socket, press and hold the Code
Setting Button for 5 seconds when re-power the Wall Socket, the Red LED will flash to indicate
that it is ready to learn the new set of operating code.
IMPORTANT: Erase the Wall Socket operating code and repeat the code setting procedure after
the Remote Control CR2032 battery has been replaced.
NOTE: If the Wall Socket operated for no reason, it is indicated that it has been interfered by other
similar Wall Socket unit nearby, reset the digital code by remove the power supply from both units
and erase the digital code as stated on point (4) then repeat the digital code setup procedure.
Wall Socket Operation
Press the button on the Remote Control unit once, it sends a wireless signal to the Wall Socket and
Red LED will blink once, it turn on the front socket power and turn on whatever is connected onto it.
Manual On/Off Switch
It is located on the front of the unit and press to On/Off the unit manually.