Product Brochure

FlexCoat is a premixed, ready to use, high per-
formance acrylic coating for exterior foundation
surfaces. FlexCoat is available in 2 and 5 gallon
pails.
FlexCoat has superior adhesion and
resilience and will resist cracking,
scratching, peeling and flaking when
applied to rigid insulation, ICF and a
variety of other surfaces.
FlexCoat is available in Concrete Grey,
White, and in custom colors upon
request.
When coating rigid foam insulation on your
foundation, be sure that the boards are
properly fastened and / or adhered to
the foundation wall. Use a rigid foam adhesive
(such as PL 300 or Clear Mastic) to bond the
foam to the wall. In some cases fasteners may
also be required. Lightly etching the boards
outer surface with a wire brush is required to
assure a quality bond to the rigid foam insu-
lation (do not gouge the boards). First tape
over the board joints with sticky reinforcing
mesh tape then pre-treat these areas with the
FlexCoat coating prior to final FlexCoat
application.
Using a nylon brush, apply FlexCoat in a 1/16 inch thick
coating over the face of the foundation using the bristles to
create the desired finish texture. Allow one to two days
for curing. Touch up any thin areas, voids or dents with
FlexCoat before you backfill.
When coating a raw foundation wall, the surface should
be clean and free of any materials such as oil or grease
that could interfere with bond. Any large spalls or broken
areas should be pre-treated with FlexCoat. Any cracks
larger than 1/16" in width should be filled with a knife
grade Lastic. Then simply brush on the FlexCoat
Coating, creating the desired finish texture as the
product is applied.
pH (wet mix) .................. approx. 10
Density (wet mix) ............ 11.5 lbs./gal.
Polymer Type .................. 100 % acrylic
Solvent system ................ aqueous
Coverage: 200 square feet per 5-gallon pail.
80 square feet per 2-gallon pail
Handling and Storage
Keep from freezing. Do not apply to frosted
or deteriorated insulation boards. Protect from
precipitation for 12 hours. Do not apply if
the temperature cannot be maintained above
40F for 24 hours. Shelf life in unopened pails
is 24-36 months when stored under cover
between 50 to 90 degrees F.
Precautions
FlexCoat is a mild alkaline based material. Do
not ingest. Avoid contact with skin and eyes.
In case of contact, flush with water. For con-
tact with eyes, get immediate medical attention
in addition to flushing. Wear safety glasses,
and protective clothing. Keep out of reach of
children and pets.
Q: Can FlexCoat be sprayed on?
A: Yes! With a Hopper Gun or small
sprayer.
Q: Can You Apply FlexCoat to Other Surfaces besides
Rigid Foam Insulation?
A: Yes! FlexCoat also bonds to brick, drywall, concrete
and other surfaces.
Q: Will FlexCoat Hold Up to Normal Wear & Tear?
A: Yes. FlexCoat is a 100% acrylic coating designed
to withstand chipping, flaking, cracking, and regular
every day abuse.
Q: Can the FlexCoat Coating be repaired if damaged?
A: Yes. Damaged areas can be meshed if necessary and
re-coated and re-textured using product leftover from
the original application.
Pre-Mixed Ready To Use - Brush-On, Easy To Apply - Durable - Variety of Textures & Colors
Concrete Grey
White
Custom Colors
Can be applied with a brush, sprayer
or drywall knife.
Styro Industries Inc. for application videos and additional FAQ's go to www.styro.net
DO NOT APPLY FLEXCOAT
IN DIRECT SUNLIGHT!