SDS

Suave Lotion – All Variants
Page:6/15
Version:
1.0
Date of issue/Date of revision:
11.09.2015
Date of previous issue:
00.00.0000
Form:Mist
ACGIH TLV 1994-09-01 TWA
10 mg/m3
Form:Mist
ACGIH TLV 2013-06-14
Form:Mist
Dimethicone
AIHA WEEL 2001-01-01 CEIL
2 ppm
Appropriate engineering controls :
Good general ventilation should be sufficient to control worker
exposure to airborne contaminants.
Environmental exposure controls :
Emissions from ventilation or work process equipment should be
checked to ensure they comply with the requirements of
environmental protection legislation. In some cases, fume scrubbers,
filters or engineering modifications to the process equipment will be
necessary to reduce emissions to acceptable levels.
Individual protection measures
Hygiene measures :
Wash hands, forearms and face thoroughly after handling chemical
products, before eating, smoking and using the lavatory and at the
end of the working period. Appropriate techniques should be used to
remove potentially contaminated clothing. Wash contaminated
clothing before reusing. Ensure that eyewash stations and safety
showers are close to the workstation location.
Eye/face protection :
Safety eyewear complying with an approved standard should be
used when a risk assessment indicates this is necessary to avoid
exposure to liquid splashes, mists, gases or dusts. If contact is
possible, the following protection should be worn, unless the
assessment indicates a higher degree of protection: safety glasses
with side-shields.
Skin protection
Hand protection :
Chemical-resistant, impervious gloves complying with an approved
standard should be worn at all times when handling chemical
products if a risk assessment indicates this is necessary.
Body protection :
Personal protective equipment for the body should be selected based
on the task being performed and the risks involved and should be
approved by a specialist before handling this product.
Other skin protection :
Appropriate footwear and any additional skin protection measures
should be selected based on the task being performed and the risks
involved and should be approved by a specialist before handling this
product.
Respiratory protection :
Use a properly fitted, air-purifying or air-fed respirator complying
with an approved standard if a risk assessment indicates this is
necessary. Respirator selection must be based on known or
anticipated exposure levels, the hazards of the product and the safe
working limits of the selected respirator.