Owner's Manual

L Series Oven Operation 11
wolfappliance.com
Time-of-Day Clock
Immediately after the oven is installed, set the 12-hour
clock to the current time of day. It may need to be reset
after a prolonged power failure. The clock is visible on the
control panel during all modes. If the upper oven timer is
set, the clock will not be visible in the upper oven control
panel display.
SETTING CLOCK
1) Touch CLOCK.
2) Touch number pads to set current time of day.
3) Touch CLOCK or ENTER to start clock.
24-HOUR CLOCK
The time-of-day clock can be changed from a 12-hour
clock to a 24-hour clock. After the clock has been set,
touch TEMPERATURE for three seconds, touch CLOCK,
then touch ENTER. Follow the same sequence to change
back to the standard 12-hour clock setting.
Fahrenheit to Celsius
The oven can be changed from Fahrenheit (°F) tempera-
ture to Celsius (°C) or vice versa.
SETTING CONTROLS
1) Oven(s) must be off.
2) Press and hold TEMPERATURE on the control panel for
5 seconds for upper or lower oven.
3) Touch COOK TIME to change to F° or C°.
4) Touch ENTER. The new display of C° or F° is accepted
10 seconds after the selection if ENTER is not touched.
Oven Timer
Each oven has a timer which operates independently from
the controls and from the other oven. Once a time is set in
hours and minutes, the countdown is seen in the control
panel display. Only the last minute counts down in
seconds.
An audible signal acts as a reminder when the amount of
time runs out. The timer will chime once at the beginning
of the last minute, then again at the end of the time. To
stop the signal, touch CLEAR. The maximum time that can
be set is 9 hours and 59 minutes.
SETTING TIMER
1) Touch TIMER for the desired oven.
2) Touch number pads to set the hours and minutes.
3) Touch ENTER to start; touch CLEAR to stop timer
setup.
4) When timing is complete, touch TIMER, then touch
CLEAR to clear the timer.