Owner's Manual
wolfappliance.com
|
7
DOWNDRAFT OPERATION
Downdraft Operation
CONTROL MODULE
1 To activate the downdraft, press the UP/DOWN button.
The drowndraft chimney will elevate and the blower will
turn on automatically to low speed. Refer to the illustra-
tion below.
2 To adjust the blower speed, press the HIGH+, MEDIUM
or LOW button. The corresponding LED will illuminate to
indicate blower setting.
3 To initiate boost mode, press and hold the HIGH+ button
for 5 seconds. Boost increases airow by approximately
20% more than high but is limited to 10 minutes. After
10 minutes, the blower will automatically transition to
high.
DELAY FEATURE
The delay feature continues blower operation for approxi-
mately ve minutes after use, then automatically turns off.
If the blower was operating on high or medium speed,
the blower will transition to the next lowest setting for ve
minutes before turning off. The chimney will stay up until the
UP/DOWN button is pressed.
Control module.
FILTER INDICATOR
After approximately 30 hours of operation, the FILTER LED
will illuminate to indicate lters need to be cleaned. Refer to
care recommendations on page 9.
To reset the lter indicator, press the FILTER button. Refer to
the illustration below.