installation instructions

Metal Side Panel (with Optional Base Cover)

7015550 / Rev A / February, 2010

Page 1 of 3

CONTAINS: QTY DESCRIPTION

1 Panel Assembly, Side

2 Bracket, Side Panel (rear)

Figure 1. Reposition Lower Front Bracket (Over / Under Models Only)

LOWER

HINGE PLATE,

OVER / UNDER

MODELS ONLY

REPOSITION

LOWER FRONT

BRACKET TO

BOTTOM

POSITION

IMPORTANT NOTE: When a side panel

is to be mounted on the hinge side of an

over / under model, it will be necessary to

reposition the lower front bracket down to

the bottom mounting position in order to

avoid interference between the lower

bracket and the lower hinge plate.

(See Figure 1)

QTY DESCRIPTION

6 Screw, #10X3/4 Drill PH Hex Wash

1 Cover, Base

1 Instruction Sheet

PAGE 1
Metal Side Panel (with Optional Base Cover) CONTAINS: QTY 1 2 DESCRIPTION Panel Assembly, Side Bracket, Side Panel (rear) QTY 6 1 1 DESCRIPTION Screw, #10X3/4 Drill PH Hex Wash Cover, Base Instruction Sheet IMPORTANT NOTE: When a side panel is to be mounted on the hinge side of an over / under model, it will be necessary to reposition the lower front bracket down to the bottom mounting position in order to avoid interference between the lower bracket and the lower hinge plate.
PAGE 2
Metal Side Panel (with Optional Base Cover) NOTE: Side panels and base cover must be installed before the unit is placed in its final position. ATTACH REAR SIDE PANEL BRACKETS TO BACK OF UNIT: 1. Align mounting holes of brackets with pre-punched locator holes along back side edge of unit, making sure bracket hooks are facing up and outward. 2.
PAGE 3
Metal Side Panel (with Optional Base Cover) HANG SIDE PANEL: 1. With the side panel held at an angle to the side of the unit, engage the front brackets behind the mainframe (See Figure 3 and Figure 5), then rotate the back of the panel toward the unit so the front brackets hook in behind the mainframe (See Figure 4 and Figure 5) and the slots at the back of the side panel align with the rear bracket hooks (See Figure 5). 2.