installation instructions

These instructions are for over/under Built-In models:
▪ Kit 7005229 for BI-36U
▪ Kit 7005230 for BI-30U
CONTENTS
1 Refrigerator door hinge-side trim filler
1 Refrigerator door handle-side trim filler
1 Refrigerator door bottom trim filler
1 Freezer drawer bottom trim
2 Freezer drawer side trim filler
1 Instruction sheet
REMOVE THE REFRIGERATOR DOOR HANDLE
1
Open the door.
2
At the top of the door, insert a flat-blade screwdriver
into the channel of the screw cover.
3
Push the screw cover away from the handle so that it
disengages from the handle.
4
Use a T-20 T
orx bit to remove the handle mounting
screws.
5
Pull the handle from the door.
INSTALL THE FRAMED DOOR PANEL RETROFIT
1
Install one refrigerator door hinge-side trim filler so that
it overlaps the hinge-side door trim.
Note: The hinge-side trim filler is approximately
3
/
32
"
wider than the handle-side trim filler. Be sure to install
the wider trim filler onto the hinge side of the door.
2
Install the door bottom trim filler so that it overlaps the
bottom door trim and hooks behind the hinge-side trim
filler.
3
Secure the ends of the door bottom trim filler with
masking tape until after the door panel is installed.
4
Install the existing 500 or 600 Series door panel.
5
Remove the masking tape from the ends of the door
bottom trim filler.
6
Install the handle-side trim filler over the edge of the
door panel on the handle side of the door.
7
Reattach the handle-side door trim.
8
Reattach the screw cover.
REMOVE THE FREEZER DRAWER TRIM
1
At the rear right-hand side of the drawer handle, insert
a
flat-blade screwdriver into the notch in the screw
cover.
Built-In Series Framed Door Panel Retrofit Kit
subzero.com 800.222.7820
7007803 REVB 10/2018
Page 1 of 2
*7007803$REVB*