Installation Instructions

7004808, 7004809, 7004810, 7004811, 7004812, 7004813, 7012623, 7012624
(Instructions for Dual Grille Kits Listed Above)
7010064 / Rev C / March, 2011
Page 7 of 7
3. Lift dual grille assembly up, align slide bracket
with slot of dual grille support bracket and
push grille assembly toward units so that
the slide bracket slides into the slot of the
support bracket (See Figure 13).
NOTE: The interaction between the slide
bracket and the support bracket allow the
grille assembly to hang freely while mak-
ing adjustments and connections at each
end of the grille assembly.
4. With grille open, install and/or tighten all
grille mounting screws at each end.
J. Dual Kickplate Installation Instructions
Note: Both units must be properly installed and
leveled before attempting to install the dual kick-
plate assembly.
1. Attach Magnetic Side Bracket Assemblies
to the outer unit bases using #10-12 X
3/4” Six Lobe Screws, two per bracket
(See Figure 14).
2. Attach Magnetic Center Bracket Assembly to
the inner unit bases using two #10-12 X 3/4”
Six Lobe Screws, one at each side (See
Figure 14).
3. Align Kickplate with magnets, then push kick-
plate toward units until magnets attract kick-
plate (See Figure 14).
4. Insert the #10-12 X 1-1/4” Truss Head
Screw through the hole at top center
of kickplate into the slot of magnetic
center bracket assembly, then tighten
the screw (See Figure 14).
Figure 14. Install Dual Kickplate
Figure 13. Install Dual Grille