Installation Instructions
Built-In Panel Mounting Kit 3
subzero.com/specs
Built-In Panel Mounting Kit
OVERLAY AND FLUSH INSET PANELS
The panel mounting kit consists of stock lengths of PVC
cleats, self-drilling mounting screws and offset gages for
correctly locating the mounting cleats on the back of
decorative panels (overlay and ush inset). Each Sub-Zero
built-in model has a page in this guide which provides the
cut length of each cleat and offset required for mounting.
This kit works for all built-in models except glass door
models (no kit available). Dual installations require two
mounting kits for sufcient cleat stock and screws.
Be sure decorative panels have sufcient thickness where
screws will be installed. If not, use the alternate hole
pattern in the cleat or locate a new pattern. Use the longer
3
/4" (19) screws wherever possible, especially along the
bottom of panels and next to a custom handle, where
most of the load will be.
When panel construction permits, use the existing hole
pattern closest to the outer edge of the cleat. Screws can
be driven through the cleat where there are no clearance
holes. This is recommended near the door handle and on
the bottom cleat of decorative panels greater than
3
/4" (19)
thick, to support the extra weight.
PANEL MOUNTING KIT CONTENTS:
• (8) 65" (1651) lengths of PVC cleat stock.
• (50) #8 x
5
/8" zip-in screws.
• (50) #8 x
3
/4" zip-in screws.
• Set of two offset gages (two offsets per gage).
• Installation guide.