Installation Instructions

Framed Handle Kit
(7014887, 7014888, 7014889, 7014890)
7014897 / Rev A / October, 2009
Page 2 of 2
DRAWER
INSIDE
SCREW COVER
TOP DRAWER TRIM
DRAWER HANDLE PROCEDURE:
1. Remove the Screw Cover from the Handle
At the back right-hand side of the drawer handle-
side trim, insert a flat blade screwdriver into the
notch in the screw cover and pry the cover away
form the handle-side trim, disengaging it from the
trim (See Figure 5).
2. Remove the Handle-side Trim from the Drawer
With a T-20, 6-lobe Torx type bit, extract the
mounting screws and pull the trim from the drawer
(See Figure 6).
3. Install the Handle on the Drawer
Place the handle against the top of the drawer,
then use a T-20, 6-lobe Torx type bit to insert the
handle mounting screws and secure the handle to
the drawer (See Figure 7).
4. Reinstall the Screw Cover
Line up the the screw cover with the handle and
push it toward the handle so that it engages the
handle clips, working it into position from left to
right, or right to left (See Figure 8).
Figure 5. Screw Cover Removal
DRAWER
OUTSIDE
HANDLE-SIDE TRIM
Figure 6. Handle Removal
SCREW COVER
HANDLE
Figure 8. Screw Cover Installation
DRAWER
HANDLE
Figure 7. Handle Installation