Installation Instructions

7004808, 7004809, 7004810, 7004811, 7004812, 7004813, 7012623, 7012624
(Instructions for Dual Grille Kits Listed Above)
7010064 / Rev C / March, 2011
A. Heater Installation Instructions
NOTE: Heater assembly MUST be attached to right side of left hand unit.
1. Clear foil from mounting holes of Heater Assembly.
2. Place heater against right side of unit with wires up and foil side in, positioning the heater 2” (51mm)
from top edge of cabinet and 1” (25mm) from back edge of cabinet (See Figure 1).
3. Using the heater as a template, mark the heater mounting holes onto the cabinet with a pencil, then
remove heater.
4. Drill a 7/64'' (3 mm) hole at each location marked in step 3.
NOTE: To avoid drilling through inner liner, use a short drill bit inserted into drill chuck so no more than
1/2” (13 mm) to 3/4” (19 mm) of bit is protruding.
5. Attach heater to unit using the #8-32 X 1/2'' Pan Head Screws at the holes just drilled.
6. Locate the panel mount 4-prong female receptacle at back side of power cord box, extract empty male
safety plug from female receptacle, then insert heater’s 4-prong male plug into female receptacle (See
Figure 1).
7. Attach the 5/16 X 1/2 Plastic Cord Clip in a convenient location by the water filter then route excess
heater wires through the clip as well as any other available wire clips.
1”
2”
Figure 1. Heater Installation
Rear View of
Power Cord Box
and 4-Prong
Heater Plug
Connection
Page 2 of 7
Extract safety plug, then
insert heater’s 4-prong
male plug